Choosing a wireless charging solution (2): foreign object detection
- # Selection
- # Foreign object detection
Note: Translated from the Chinese original.
This part covers the next factor in choosing a wireless charging solution:
- Safety with metal foreign objects (FOD)
Mid- and high-power wireless charging solutions typically transfer power at frequencies from tens of kHz to just over 100 kHz. At these frequencies common metals are heated by eddy currents — the same principle as an induction cooktop. Wireless charging, however, aims to transfer power efficiently, not to heat things. If a metal object sits in the charging area, eddy currents keep heating it, which can damage equipment or even start a fire. Industrial wireless charging solutions should therefore avoid eddy-current heating, improving both efficiency and safety.
Discussions of industrial wireless charging tend to focus on efficiency, size, charging distance and certification, but these are only the basic requirements. One item that matters just as much, and is easy to overlook, is “FOD”: foreign object detection.
In phone wireless chargers, where power is low and the distance short, FOD is not hard to implement and is widely used. In mid- and high-power industrial applications from a hundred watts up to kilowatts, however, power is higher and the charging distance larger, so the electrical change caused by a metal object is relatively smaller. Highly sensitive FOD becomes much harder to achieve and calls for deep experience and precise software algorithms. It belongs on the checklist when you select a solution. Tseetech’s wireless charging solutions provide highly sensitive metal-object detection and protection for coins of different sizes and at different charging distances, in both standby and operating modes. In real applications this helps reduce the safety risk of metal objects getting into the charging area.